GNU Tools Debug with Simulator
(45 mins) Released: 01/21/2010 Updated: 04/01/2010

This course explains the basics of GNU tools, including the concept of free software, the history of GNU software and its licensing. It also explains the benefits of using GNU tools.
(35 mins) Released: 12/28/2009 Updated: 12/28/2009

This course explains what interoperability means with regard to the Renesas SHC compiler and the KPIT GNUSH compiler, and how it is achieved between these compilers.
(10 mins) Released: 12/28/2009 Updated: 12/28/2009

This course covers three common problems that can arise during the process of debugging an application: memory access errors, exception errors, and address errors. It explains what causes these errors and offers advice on how to solve them.
(10 mins) Released: 12/28/2009 Updated: 12/28/2009

This course provides a step-by-step guide to the straightforward process of installing the KPIT GNU toolchain on the PC on which you will run the Renesas HEW IDE for debugging application software.
(30 mins) Released: 12/28/2009 Updated: 12/28/2009

This course describes the process of debugging an application on an SH target — a SuperH™ MCU — in HEW using the KPIT GNU toolchain and the Renesas E10A-USB emulator. The course explains how to create a new project, make linker settings, configure the debug platform, and connect to the target system. Then it steps through the process of debugging a typical application with this setup.
(20 mins) Released: 12/28/2009 Updated: 12/28/2009

This course describes the process of debugging an application on an SH target — a SuperH™ MCU — in the High-performance Embedded Workshop (HEW) using the KPIT GNU toolchain and the Renesas HMON monitor. The course explains how to create a new project, configure the debug platform using a familiar GUI, configure the Flash Development Toolkit (FDT), and download your application on the target. The course then steps you through the process of debugging a typical application with this setup.
(50 mins) Released: 12/28/2009 Updated: 12/28/2009

This course describes the three types of GNU utilities supported by the KPIT GNU toolchain and then explains what each of the utilities does and how it is used.
(35 mins) Released: 12/28/2009 Updated: 12/28/2009